Oct 22, 2010 · To simulate a mic, use a voltage source that makes the same output as the real mic. To simulate an audio (non-critical) circuit with a transistor you don't have in the library, look up the data …

Nov 9, 2018 · I'm attaching an LTspice file that simulates a crystal oscillator with resonant frequency 1MHz, and it works fine. But if I change L1 from 2.5 H to 9.8 mH to simulate a crystal oscillator with …

Feb 15, 2013 · Hi, I wrote UART code that sends UART data to the PC. I want to simulate it and therefore need to see a terminal that will present the data being sent to the PC from the PIC during …

Jul 28, 2021 · I would like to simulate a small signal RF amplifier on VHF. Can LTSpice simulate RF and if so can anyone point me to a tutorial that shows the proper set-up for LTSpice? Thanks...

Dec 23, 2019 · I have been trying to simulate a VCO for a CB radio on LTspice, but cannot get it to run. The ac analysis give me a peak at about 3.5 MHz but cannot get anything from the .trans. It is …

Oct 19, 2011 · Problem getting LTSpice to simulate with CD4000.lib Doktor Jones Oct 19, 2011 Prev 1 2

Dec 23, 2015 · Hello I make a simple simulation of a dc current source applied on a 10 Kohms thermistor. When I perform a transient simulation (I1 = 10 mA until 10 s) , the thermistor warms up …

Jul 7, 2010 · You cannot simulate a motor or a globe. Both take a very high current at the beginning and the driving device plus the power supply must be able to deliver this current.

Jul 26, 2016 · In connection with this other thread, I developed LTspice simulation models respectively for single and dual-coil DPDT latching relays, based on data from...

Mar 27, 2015 · Hello I tried to simulate a NTC thermistor with Orcad Pspice lit. following some models found on the web, I replaced the NTC by a VCCS with gain depending on TEMP. Netlist is joined but …